in News Departments > Products & Technologies
print the content item

HYTORC, a division of UNEX Corp. based in Mahwah, N.J., has introduced a new pneumatic torque tool. The FLIP is available in four sizes for a torque range between 200 and 5,400 foot-pounds and bolt sizes from 0.5-inch to 2-inch diameter.

Pre-torque of fasteners for parallel joint closure is accomplished quickly with up to 1,800 revolutions per minute, according to HYTORC.

According to the company, the FLIP is fast and vibration- and echo-free. Also, the dual-speed torque tools are limited to not more than 100 revolutions per minute to avoid injury with swinging reaction arms.

For more information visit hytorc.com.



Trachte Inc._id1770
Latest Top Stories

Senate Passes Tax Extenders Bill With Wind PTC Extension

The legislation, which passed in the U.S. House earlier this month, will renew the critical production tax credit through the end of 2014 - giving developers only about two weeks left to start construction.


Transmission Study Shows Nebraska Could Handle A Lot More Wind Power

A new report released by the Nebraska Power Review Board finds that the state already has enough infrastructure to accommodate at least 2 GW of additional wind generation.


Can Wind Energy And Birds Coexist? Environmental Group Says Yes

The Environmental Defense Fund, a supporter of responsible wind energy development, points out ways to help mitigate impacts of turbines on birds and bats.


Another Study Finds Wind Turbines Do Not Affect Nearby Property Values

Research conducted by the University of Guelph focused on regions in Ontario, and the conclusion echoes that of previous studies.


Too Little, Too Late? U.S. House Approves Wind PTC Extension

The U.S. House of Representatives has passed a tax extenders package that would renew the wind production tax credit (PTC) and about 50 other expired tax breaks through 2014. The wind industry argues the short-term fix is virtually no fix at all.

Hybrid Energy Innovations 2015